Re-printing of Verifone Card Receipts (Last Transaction Only)

Re-printing of Verifone Card Receipts (Last Transaction Only)

This article is not intended for end-users but for Fidelity & Resellers to configure your back-office system.

Following a request to turn off Verifone card receipts there are a couple Macro's which are required in order to re-issue receipts. This is something that is added per site in Total Control Premier.

If you open up the application Total Control Premier and down the left-hand side sub-menu if you expand 'GPOS Specifics' as below and select Macros.

Macros are a series of key presses that can be replayed at the touch of a single button. 


(Screenshot 1.1)

This will open up the Macro screen where you can add new macros to the system;


(Screenshot 1.2)

If you click on 'Add' you can create a new macro for the 'Re-Printing of Verifone Card Receipt (Last Transaction Only) as in screenshot 1.3 dragging across the system keys for example,

Just to expand on Macros are a collection of records that when executed, are played back in the sequence they were added.


(Screenshot 1.3)

Reprint Customer Copy, you will need to drag across 8, 8, 8, 8, 8, 8, 6 followed by dragging and dropping in the system operation (50). You can use the description field to search shown in Screenshot 1.4.

Reprint Merchant Copy, you will need to drag across 8, 8, 8, 8, 8, 8, 7 and again dropping in the system operation key as in screenshot 1.5.

After going into Macros for the specific site, click add at the top then mimic the two keys on the screen

Re-Print Verifone Customer Copy


(Screenshot 1.4)

Re-print Merchant Copy


(Screenshot 1.5)

    • Related Articles

    • Disabling receipts printed during card transactions

      The system produces up to 3 per EFT transaction and we can choose which, if any, are produced. The options are:- GPoS VAT receipt – previously compulsory but from v158 upwards we can change this to follow the receipt setting. I.e. if the receipt is ...
    • Verifone P400 GPoS Setup

      GPoS Setup Peripheral Setup Open GPoS Utility Open  Programming  >  System Tables  >  Peripherals Click or tap on  Add  , and give the Peripheral an appropriate name, eg “ Verifone ”, “ EFT ”, “ P400 ” etc Set the  Peripheral Type  to  Verifone ...
    • Verifone P400 Overview

      Introduction The P400 terminals are part of the Engage range, which have been introduced by Verifone to replace the VX range, which by the end of 2020 will be retired and discontinued. No additional software is needed, as the terminals communicate ...
    • Using Macros to automate GPoS functions

      Introduction Macros can be used to automate actions in GPoS, from something simple like entering a denomination and then cashing it off, to something more complex like running Reports and Period End routines. This guide takes you through the basics ...
    • EFT Re-Print Macro's

      Setting up additional Till buttons to allow the print of customer and merchant receipts – Last Transaction Only After turning off card transaction receipts for either the merchant, customer or both you will need a way to print it on request should ...