Removing scanner cable from 1450/70G Honeywell scanner

Locate the pin hole on the right hand side as shown below. Press an unfolded paper clip into the side, whilst pressing this in you will be able to wiggle and pull the cable from the underneath.

• Related Articles

• Honeywell 1452/1472g Troubleshooting

  Points to Check Check that the data cable is plugged in to the base correctly and securely, and that the other end is plugged in to the POS terminal correctly Try cleaning the contacts on the base and the scanner before trying to charge the scanner ...

• Honeywell Voyager XP 14XX Setup

  The Honeywell 1450/1452 and 1470/1472 series scanners can be programmed by scanning the barcodes found below. Function Barcode Reset All Defaults USB Serial (COM) Emulation USB Keyboard Wedge Add CR Suffix Remove Suffix Revision Information - Print ...

• Honeywell HF680 Setup Guide

  Enter/Exit Configuration - Recall Defaults - Defaults are shown with * Operating Modes - Use defaults. No need to change unless the customer says that the IR trigger mode is scanning Barcodes in error. USB Serial - Baud Rate - 115,200 Baud can be ...

• Setting Scanners to be in Presentation mode out of their stand

  Scanners are typically designed to work so that when they are not sat in a stand or base, they need to be triggered to scan a barcode, and will only scan a presented barcode automatically if they are in a stand. Some scanners can be programmed to be ...

• Scanner settings on HHT Skorpio's

  This guide will show you how to check that the scanner options are set correctly on the Skorpio x3 and X4 HHT units. To start off we will need to load the Decoding applet. This can be found in the control panel. The control panel is accessed by ...