Please see below the bluetooth re-pair instructions:
1. Restart the terminal. To turn off, remove from the charging cradle and hold down the red Cancel button for approx 5 seconds. To turn on, hold down the green Enter button or place in to the charging cradle – terminal will turn on after approx 3 – 5 seconds.
2. Press SETUP (touch-screen) when display shows; “PRESS ENTER TO START COMMUNICATION”
3. Enter the setup password of ‘2580’ followed by the green Enter button.
4. Press “1” Network Settings
5. Press the down arrow (touch-screen)
6. Press “1” BT Base Settings
7. Press “2” Reset BT Base
8. Enter MGR PIN (5555)
9. Select YES when prompted with “DO YOU WISH TO RESET BLUETOOTH SETTINGS ?” Setting will be cleared and return to previous screen
10. Press the Blue button on rear of the Bluetooth Charging Cradle - the Blue light will begin to flash
11. Press “1” BT Base Scan
12. The terminal will search Bluetooth signals and show a list of available devices after approx 30 seconds.
13. Select the “MAC:” number that matches number shown on underside of Bluetooth Charging Cradle. The terminal will show “Connecting” for a few seconds before returning to previous screen
14. Press the red Cancel button three times to go back to the initial “PRESS ENTER TO START COMMUNICATION” screen.
15. Press the green Enter button to start communications
16. The terminal should connect and show the Login ID prompt after approx 30 seconds.
Related Articles
Verifone P400 Overview
Introduction The P400 terminals are part of the Engage range, which have been introduced by Verifone to replace the VX range, which by the end of 2020 will be retired and discontinued. No additional software is needed, as the terminals communicate ...
Verifone P400 Troubleshooting
Check the Network Connection Check the Network Status 1. Press or touch the blue Verifone banner on the screen 2. Press 2 or touch Supervisor (this screenshot is from a non-integrated terminal, and shows Supervisor as option 3 due to the additional ...
Verifone Status Page
A page displaying the current status of the Verifone service along with any known Service Notifications: https://www.verifone.com/en/uk/service-notifications
Verifone P400 GPoS Setup
GPoS Setup Peripheral Setup Open GPoS Utility Open Programming > System Tables > Peripherals Click or tap on Add , and give the Peripheral an appropriate name, eg “ Verifone ”, “ EFT ”, “ P400 ” etc Set the Peripheral Type to Verifone ...
Verifone Unexpected Pinpad Attached
The "Unexpected Pinpad Attached" Error occurs when Ocius Sentinel is unable to validate the pinpad online with Verifone. This is usually the result of the software being unable to communicate with Verifone's servers, such as in the event of a dropped ...