This guide is not intended for End Users to follow. A competent Fidelity Installer or Reseller should install the chip and pin

How to setup WorldPay IPC/Total with GPoS

IPC Settings Specific to integration with Fidelity GPoS

Locate your Easy V Terminal installer and double click the Setup Icon.

When prompted for the installation folder name leave this as default unless you require otherwise (this will not affect GPoS), then click install.

Once Easy V Terminal has been installed use My Computer to browse to the Easy V Terminal folder C:\YESEFT is the default , in this folder you will find a file called YESEFT Config.exe double click this file.  You will be presented with the setup screen.  The settings you need to change are towards the bottom of the screen. By default the general TAB will be selected.

The essential settings to be set on the general TAB are :-

1. The Environment must be set to - POS

Click on the Receipt TAB.

The essential settings to set on the Receipt TAB are :-

1. Receipt Width - set to match the char width of you receipt printer TM88II printers = 42
   
2. Print Receipt - Ensure this is Unticked
   

Click on the Look n Feel TAB.

The essential setting on the Look n Feel TAB are :-

1. Always on top
   

Once you have changed the above settings click OK to save the settings.

*********We advise being connected to the internet from this point onwards***********

Locate your Easy V Terminal installer and double click the Emboss Setup.bat file

You will be prompted to enter the Instance ID. Press enter for the default instance (presuming you used default instance in YESeftconfig as we instructed

You will be prompted to key in your "Merchant ID" key this in and press enter (this will have been provided by Yespay)

You will be prompted to key in your "Terminal ID" key this in and press enter (this will have been provided by Yespay)

If this has been completed successfully you will see the message below

Press any key to exit the configuration setup.

Running WorldPay

To start WorldPay running you need to double click on the StartPOSServer file found in the install folder. We recommend putting a shortcut to this file into the startup. 

Configuring GPoS

Setting up the Peripheral

You need to add a peripheral under the peripheral.  The peripheral you need to add is Emboss YesPay NOT EFT.  Give the peripheral a recognizable name e.g. WorldPay.

Setting System Options

Firstly, you need to enable the peripheral in the system options.  If you go to system options grouped, then the peripherals tab.  The option you require is #218, if you double click the option, you will get a list to select the EFT devices added to the system.

Secondly, you need to check the settings under the EFT tab in system options.

1. EFT Delay between receipts - this can be left at 0 unless you have problems with YesPay receipts
2. EFT Hospitality Mode - set this to FALSE when using a wired chip and pin terminal.
   

Setting up the Payment Types.

Under databases select payment types.  You will need to either add a payment type for Cards (or whatever description you choose) or edit an existing payment type.

Setup your payment type as per normal but ensure that the following options are ticked

• Is EFT
  
• Over Tender prohibited
  

P400 Additional Configuration