Others
Removing scanner cable from 1450/70G Honeywell scanner
Locate the pin hole on the right hand side as shown below. Press an unfolded paper clip into the side, whilst pressing this in you will be able to wiggle and pull the cable from the underneath.
Honeywell HF680 Setup Guide
Enter/Exit Configuration - Recall Defaults - Defaults are shown with * Operating Modes - Use defaults. No need to change unless the customer says that the IR trigger mode is scanning Barcodes in error. USB Serial - Baud Rate - 115,200 Baud can be ...
Setting Scanners to be in USB Serial Emulation mode
Scanners can be operated in USB Serial Emulation mode, which means that the scanner connects to the POS terminal as a virtual serial device. This can be done either with a utility provided by the manufacturer, or by scanning programming barcodes. ...
Setting Scanners to be in Presentation mode out of their stand
Scanners are typically designed to work so that when they are not sat in a stand or base, they need to be triggered to scan a barcode, and will only scan a presented barcode automatically if they are in a stand. Some scanners can be programmed to be ...
Honeywell Voyager XP 14XX Setup
The Honeywell 1450/1452 and 1470/1472 series scanners can be programmed by scanning the barcodes found below. Function Barcode Reset All Defaults USB Serial (COM) Emulation USB Keyboard Wedge Add CR Suffix Remove Suffix Revision Information - Print ...
Honeywell 1452/1472g Troubleshooting
Points to Check Check that the data cable is plugged in to the base correctly and securely, and that the other end is plugged in to the POS terminal correctly Try cleaning the contacts on the base and the scanner before trying to charge the scanner ...