SCO Mode Welcome Screen Messages
This article applies to GPoS version 1.62 and higher -
screenshots are taken from GPoS version 1.66.
GPoS SCO Mode's welcome screen has two blocks of default text -
"Scan your first item or touch here to begin" on a button in the
middle of the screen, and "This terminal accepts Contactless and
Chip + PIN payments" and these can be altered to display custom
messages.
These are Messages and Texts that are edited in the GPoS Utility as
per other warnings and messages that are displayed throughout the
course of normal GPoS operation.
GPoS Utility
| 1. Click Programming > System
Tables > Messages and Texts | |
2. Edit the text(s) as required:
The built-in default may be different to the default
programmed by the installation or support technician | |
| 3. Close Messages and Texts and click Yes to save the changes |
Related Articles
Setting up Payment Types
Setting up Payment types. This can be done inside Total Control under "GPOS specifics" and then "Payments List", here you will see a list of the current payment types and some options on what to do next. To create a new payment key just click "add" ...GPOS/SCO Restrictions - How to setup
SCO Restrictions Gpos/SCO Restrictions are set by POS options at a Group Level. There is a further restriction option to define the type of restriction such as Medicine etc. It does not define a limit of any medication this is still a clerk operating ...Changing the SCO screen logo
Changing the SCO screen logo. To change the logo on your SCO screen you have to edit the config file from the GPOS folder. Firstly close down the SCO software and then go to file explorer. Go to the following location: “C:\Program Files ...Adding a new screen page in Touch Screen Layout.
Please note that this is intended as a basic guide to show how you to create a new screen page and add buttons to it. As mentioned in the last step, nothing you change here will be saved unless you explicitly select to Save and Close. So you can ...Verifone P400 GPoS Setup
GPoS Setup Peripheral Setup Open GPoS Utility Open Programming > System Tables > Peripherals Click or tap on Add , and give the Peripheral an appropriate name, eg “ Verifone ”, “ EFT ”, “ P400 ” etc Set the Peripheral Type to Verifone ...